Sand making machine knowledge of installing and commissioning

Liming Heavy Industry is a company with 20 years of professional experience Sand Production R & D companies for domestic and foreign customers with more than 20,000 high-quality products and excellent after-sales service and technical support perfect.
Sand grain size of the largest feed into the machine will normally take rigorous technical performance parameters of the table provides the granularity of the provisions of particle size is larger than is strictly prohibited materials into the sand making the general into the feed size range is 3-5 centimeters long. Liming Heavy Industry developed in the following two kinds of sand making general formula feeding: 1. Center for feeding and feeding off the waterfall. 2. The whole center into the material. System, the maximum moisture content of sand material is 20% or less, the general Jingxi ore mining machine out of sand directly into this mechanism. Sand of a material particle size and ore properties and particle size on feeding, ore friable, granular material into the smaller size of their products the higher the pass rate, and vice versa is low, change the impeller speed, but also can be adjusted granularity.
Sand works: Impact Sand Stone from falling into the upper part of straight high-speed rotation of the wheel, under the effect of centrifugal force at high speed, with another part of the umbrella way to divert the impact of the wheel around the block produced high-speed and high impact the density of broken stone in the fight against each other, then they will in the turntable and the chassis formed between the vortex motion caused by the fight against each other many times, rubbing, broken, until broken into the required size.
Sand in the actual production, in general, to be installed on the concrete structure on the basis of or just based on the foundation should be able to withstand four times the weight of the machine. According to Sand production sites (factories or open) different, the installation should be leveling with the horizontal axis perpendicular to it. Sand should be set at the top of lifting equipment, lifting equipment capacity by Sand's largest piece weight considerations, should be left in the sand making the top of the lifting of space, in the left side of the sand making adequate space to prepare for repair time. Before installing the machine, according to an inventory of packing list, check the various pieces of whether the damage during transport, spare parts and spare parts are complete.
Sand Making Machine commissioning:
Air load operation: load test run time of 4 hours; test before hand panel moving pulley should rotate flexible; Sand to be running smoothly, the body should not have severe vibration, no abnormal noise, the otherwise, should stop inspection; bearing temperature l can not exceed 45 ℃, or the maximum temperature not exceeding 75 ℃, otherwise, should bearing cleaning.
Load test run: into the feed particle size of various models in strict accordance with specifications, provides more than is strictly prohibited materials into; to feed evenly continuous, and to achieve the Sand Charging Capacity up to full capacity (ie, electric current is rated current); load commissioning time, 8-24 hours; bearing temperature rise shall not exceed 45 ℃ or maximum temperature not exceeding 75 ℃.
Liming Heavy Sand products mainly include: PCL Direct Impact Sand, VSI sand making efficient vertical shaft Pelton, 5X the impact of high-performance centrifugal type sand making machine, the product can meet the current domestic production of many industries require a variety of sand . Liming Heavy Industry welcomed the new and old customers to plant paid an inspection visit.